Canon REALiS X600 - Manual (Page 78)

User Command Specifications 9. Details of command RC
"i:OK" is returned when the button press request has been acknowledged successfully.
(It does not indicate if the operation for the pressed button was executed properly.)
-1
■ Note 1
■ Note 2
- USB mouse function
- Function for transfer to special mode (service mode)
■ Note 3
Be absolutely sure to send the '*-REP' parameter, and end the button pressing last of all.
The button pressing is ended in the cases below as well.
<1> When a panel or remote control button has been operated
<2> When an 'RC' or 'MAIN' command has been received
<3> When operation has transferred to the remote mode
Setting
> RC POWER
< i:Ok
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
○ ○ ○
○ ○ ○
* If a command cannot be supported, 'INVALID_MODE' is returned as an error response.
It can only be used during Local mode.
01.00** 01.01**
Response
Example
This emulates pressing of the remote control buttons for controlling the projector. Description
The following functions are unavailable in remote control emulation.
With the emulation of the remote control operations, the functions of the buttons corresponding
to the parameters cannot necessarily be executed.
Emulation simply consists in emulating the pressing of the buttons.
SX50 SX6 SX60 X600
A parameter with '+REP' signifies "button press start." (This is the same as the status in which
the remote control button is held down.)
○ ○
01.01** 01.01**
Model Power Input Mode
Remote Local
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
SX50 ○ ○ ○ ○ ○ ○ – – ○ × ○
SX6 ○ ○ ○ ○ ○ ○ ○ ○ ○ × ○
SX60
X600
Commands
supported
○ ○
PAGE 70