Canon REALiS X600 - Manual (Page 44)

User Command Specifications 9. Details of command WB
1 WB
WB
WB=：ＩＤ>
Screen color correction parameters
Meaning
Standard
Blackboard
Adjust
-1
A "busy" response is given while the zoom or focus lens is being driven.
-2
Menu
[Image adjustments] - [Screen color correction]
[Display settings] - [Screen color correction]
-3
-4
When the model SX6, SX60 or X600 is used, a set of settings is established for the system.
-5
Control
> WB=NORMAL This sets the screen color correction to “Normal”.
< i:OK
Reference
> GET WB or ?WB This retrieves the screen color correction.
< g:WB=GREENBOARD
Acquisition of parameters which can be set
> RANGE WB
<
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
r:WB=I,NORMAL,GREENBOARD,ADJUST
Parameter
NORMAL
This command is the same as the menu functions in the table below.
GREENBOARD
ADJUST
SX50
X600
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
For details, refer to the RANGE command.
For all other responses, refer to "Error List."
ID
Mode Control Setting Reference
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
Commands
Function
Parameter
Format
Example
The screen color correction is set to “Normal”, “Blackboard”, or “Adjust”.
Screen color correction
"i:OK" is returned if the parameter was set properly.
Description
Response
The current screen color correction can be acquired using the applicable GET command.
Model
SX60
SX6
SX50
01.00** 01.01** 01.01** 01.01**
Model Power Input Mode
Remote Local
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
SX50 ○ ○ ○ ○ ○ ○ – – ○ ○ ×
SX6 ○ ○ ○ ○ ○ × ○ ○ ○ ○
SX60
X600
○
(Refer to the ZCONTDRV command and FCONTDRV command.)
For details, refer to the GET command.
○ ○ ○ ○
When "ADJUST" has been selected, adjust the RGB adjustment values using the WBRGB
command.
When the model SX50 is used, the currently selected input signal and image mode settings are
established.
"NORMAL," "GREENBOARD" or "ADJUST" can be
set for the screen color correction.
Commands
supported
SX6 SX60 X600
PAGE 36