Canon REALiS X600 - Manual (Page 59)

User Command Specifications 9. Details of command BVOL
1 BVOL
BVOL
BVOL=
Beep sound setting
-1
A "busy" response is given while the zoom or focus lens is being driven.
-2
-3
-4
Setting
> BVOL=0 This mutes the BEEP sound.
< i:OK
Reference
> GET BVOL or ?BVOL This retrieves the BEEP sound output state.
< g:BVOL=1
Acquisition of parameters which can be set
> RANGE BVOL
< r:BVOL=I, 0, 1
"0" or "1" can be selected as the beep sound setting.
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
BEEP sound setting
This command is identical to the Beep function in the System settings menu.
ID
BEEP sound mute
1 BEEP sound output
Parameter Meaning
Example
"i:OK" is returned if the parameter was set properly.
This sets the BEEP sound output. Description
The current beep sound output status can be acquired using the applicable GET command.
The beep sound can be set even while the sound is muted, but it will not sound even if (beep
sound output) has been set.
For details, refer to the GET command.
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
0
Commands
Function
Response
Parameter
01.00** 01.01** 01.01** 01.01**
SX50
○
SX6 SX60 X600
Model Power Input Mode
Remote Local
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
SX50 ○ ○ ○ ○ ○ ○ – – ○ ○ ×
SX6 ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ×
SX60
Format
X600
Mode Control Setting Reference
Commands
supported
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the RANGE command.
For all other responses, refer to "Error List."
(Refer to the ZCONTDRV command and FCONTDRV command.)
○ ○ ○
PAGE 51