Canon REALiS X600 - Manual (Page 164)

User Command Specifications 9．Details of command RANGE VKS/HKS
1 RANGE VKS/HKS
RANGE VKS/HKS
Vertical keystone setting range inquiry Horizontal keystone setting range inquiry
RANGE□VKS RANGE□HKS
r:VKS=N, ,
r:HKS=N, ,
-1
A "busy" response is given while the zoom or focus lens is being driven.
-2
> RANGE HKS
< r:HKS=N, -30, 30
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* If the necessary signals are not input, 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
Commands
supported
Reference
For all other responses, refer to "Error List."
This inquiry can be made when the projector is in both the remote mode and power-on status
at the same time.
(Refer to the ZCONTDRV command and FCONTDRV command.)
Commands
Function
Format
Example
Description
Setting
The vertical and horizontal keystone settings can be selected by the VKS and HKS commands,
respectively.
Response
Vertical/horizontal keystone setting range request
These inquire about the ranges within which the vertical and horizontal keystone can be set.
Number
Mode
SX50 SX6 SX60 X600
Control
01.00** 01.01** 01.01** 01.01**
○ ○ ○ ○
Model Power Input
D-RGB A-RGB1 A-RGB2 Comp Video
Mode
Remote Local
Remarks
S-Video D-Video SCART None
SX50 ○ ○ ○ ○ ○ ○ – – Ч ○ Ч
SX6 ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ×
SX60
X600
PAGE 156