Canon REALiS X600 - Manual (Page 97)

User Command Specifications 9．Details of command GET PROG
1 GET PROG
GET PROG
GET□PROG
?△PROG
g:PROG=
For all other responses, refer to "Error List."
-1
A "busy" response is given while the zoom or focus lens is being driven.
（Refer to the ZCONTDRV command and FCONTDRV command.）
With some input signals, it may not be possible to make this inquiry.
-2 The significance of the response differs slightly depending on the model concerned.
Significance of response
-3 The progressive setting can be selected by the PROG command.
> GET PROG or ? PROG
< g:PROG=1
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
○ ×
X600
Ч ○ Ч
SX60
○ ○ × SX6 Ч Ч Ч
– Ч ○ Ч
SCART None
SX50 Ч Ч Ч ○ ○ ○ –
Mode
Remote Local
Remarks
Model Power Input
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video
X600
Model
SX50
Regardless of the progressive setting, "ON" is indicated when the current
progressive conversion processing function is working; "OFF" is indicated when the
processing function is not working.
SX6 This signifies the progressive value setting.
SX60
○
○ ○
2 AUTO × ○
1 On ○
Response
Errors supported by model
SX50 SX6 SX60 X600
Meaning
○
○ ○
This inquiry can be made when the projector is in both the remote mode and power-on status
at the same time.
Commands
supported
○
01.01**
○
01.00** 01.01**
Progressive value setting inquiry
Reference Mode Control Setting
○
Off ○ ○
X600
Commands
Function
Format
Description
Response
This inquires about the current progressive (status) value set.
0
ID ○
01.01**
○
Example
SX60 SX50 SX6
PAGE 89