Canon REALiS X600 - Manual (Page 14)

User Command Specifications 5. Control Mode
1 5. Control Mode
The table below shows the states and limitations of the LOCAL and REMOTE control modes.
Mode
Item
Status State indicator Constant remote indicator ※2
ALM ALM state indicator ALM state indicator
・ AC power supply to projector ・ REMOTE command
・ Manual power on/off
・ LOCAL command
・ Power management standby/exit mode transfer
Main unit keys All available Only POWER button is available
Emulation Available ※ 1 Not available
5 minutes elapsed from no signal Operation is as follows depending on the model.
・
・
・
・ Signal input ・ REMOTE command
・ Remote control button pressed
・ Main unit button pressed
・ Emulation
For the SX50 All commands except for "RC" and "MAIN"
REMOTE
LOCAL
GET
MODE
MAIN
RC
For the SX6, SX60 or X600
GET COMVER
GET ERROR
GET FREEZE
GET INPUT
GET LAMPCOUNTER
GET MODE
GET MUTE
GET NOSHOWSTATUS
GET POWER
GET PRODCODE
GET ROMVER
GET SIGNALSTATUS
LOCAL
MAIN
RC
REMOTE
Special mode Executable with remote control or main unit buttons Not executable in any state
(Service mode)
*1 However, switching to the USB mouse function or Special mode is not allowed.
*2 If the control mode is REMOTE, the following are displayed regardless of whether the power is on or off.
*3 When the power management setting is "standby" or "exit"
LED indicator pattern during REMOTE mode
■ ■
Mode where projector control/operation is
performed by a PC or other external device.
(The PC or other external device is connected by
a serial cable.) Mode where projector control/operation is
performed by the main unit or remote control.
Initial mode when microcomputer is started.
5. Control Mode
LOCAL mode
Description
REMOTE mode
Remote control
keys All available
Command/parameter Remarks
Commands supported
Command/parameter Remarks
5 minutes elapsed from no
signal
Model
Return
No switching to standby or exit
mode.
Transition method
Operation
Operation
buttons
LED
Switching Power
management
standby and exit
modes
※ 3
Control is switched to "local
mode" after mode switching.
SX6
SX60
X600
SX50
Only POWER button is available
PAGE 9