Canon PIXMA MX870 - Manual (Page 397)

Advanced Guide > Printing Using the Operation Panel of the Machine > Copying > Making Copies > Displaying the
Preview Screen
Displaying the Preview Screen
When copying the original set on the Platen Glass, pressing the center Function button in the Copy
standby screen allows you to preview an image of the printout on the preview screen.
Important
The preview screen may not be available depending on a copy method.
The original will be scanned to display the preview image. Therefore, do not open the Document
Cover until the preview screen appears.
Originals are rescanned after displaying the preview screen and before copying starts. Therefore,
do not open the Document Cover or remove the original from the Platen Glass until copying is
complete.
1. Load the original on the Platen Glass.
Note
Preview is not available when you load the original in the ADF.
2. Press the center Function button.
3. Confirm the instruction on the LCD, then press the OK button.
After scanning is complete, the preview screen is displayed.
1. Preview of the original
The original that is set on the Platen Glass is displayed. If the displayed image is skewed, refer to
Loading Paper / Originals and reset the original properly, then display the preview screen again and
preview the original.
2. Page size
A frame showing the selected page size appears over the image. The inside of the frame will be
printed.
3. Magnification
The magnification setting, which was set when the preview screen was displayed, is displayed. If
the setting other than Fit to page is selected, you can change the magnification setting using the
button.
Page top
Page 397 of 1127 pages Displaying the Preview Screen