Canon PIXMA MX870 - Manual (Page 20)

Advanced Guide Troubleshooting
Contents > Preparing for Faxing > Specifying the Basic Settings for Faxing > Setting the Date and Time
Setting the Date and Time
Note
When the machine is connected to a computer with the MP Drivers installed, the date and time
setting will be copied from the computer to the machine. As long as the date and time are set
accurately on your computer, you do not need to set them on the machine.
If you disconnect the power plug or when there is a power failure, the date and time setting on the
machine will be reset. When you connect the machine to a computer with the MP Drivers installed,
the setting may be copied to the machine once again.
1. Display the Date/time setting screen.
(1) Press the Setup button.
(2)
Select Device settings , and press the OK button.
(3)
Select Device user settings, and press the OK button.
(4)
Select Date/time setting, and press the OK button.
2. Enter the date and time.
(1)
Use the Numeric buttons to enter the date and time (in 24-hour format).
Enter only the last two digits of the year.
Note
You can also use the or button ( Scroll Wheel ) to enter the number.
If you misentered the date and time, use the or button to move the cursor under the
wrong number, and reenter the correct number.
(2)
Press the OK button.
Note
The date display format can be selected from three formats: YYYY/MM/DD, MM/DD/YYYY,
or DD/MM/YYYY (Date display format).
3. Press the FAX button to return to the fax standby screen.
Page top
Page 20 of 1127 pages Setting the Date and Time