8 code table for ﬁstandardﬂ series, Code table for “standard” series, Configuration – Lenze 8200 Frequency inverters User Manual

Page 214: 8 code table for “standard” series

Configuration

8200SHB0199

7-77

7.8

Code table for “Standard” series

How to read the code table:

Column

Abbreviation

Meaning

Code

C013

Code C013

The parameter of the code can be different in PAR1 and PAR2.

The parameter value is accepted immediately (ONLINE).

C009*

The parameter value of the code is always the same in PAR1 and PAR2, but is
always displayed in PAR1.

C001

The parameter value of the code will be accepted after pressing SH+ PRG.

[C002]

The parameter value of the code will be accepted after pressing SH+ PRG but
only, if the controller is inhibited.

C010

Parameter value of the code will only be displayed in [Hz], if C500 = 2000 and
C501 = 10 (factory setting). See chapter 7.6.3.

Name

820X

Name of the code.
Unit-specific setting possibilities (here for 820X).
Without unit designation the code is valid for all unit types.

Lenze

Factory setting of the code

The column ”Important” contains further information

Choice

{1 %}

99 Min. value

{Steps/Unit}

Max. value

Info

Meaning of the code

IMPORTANT

Additional, important explanation of the code

Code

Name

Possible settings

IMPORTANT

Code

Name

Lenze

Choice

Info

IMPORTANT

C001

¤ Operating mode

-0-

Setpoint selection via term. 8
Control via terminals
Parameter setting via 8201BB

-1-

Setpoint selection via 8201BB or
LECOM
Control via terminals
Parameter setting via 8201BB

-2-

Setpoint selection via term. 8
Control via terminals
Parameter setting via LECOM

-3-

Setpoint selection via LECOM
Control via LECOM
Parameter setting via LECOM

Page 7-9,

7-42

[C002]* Parameter set

-0-

Function executed

-1-

Overwrite PAR1 with factory setting

-2-

Overwrite PAR2 with factory setting

-3-

Overwrite PAR1 and PAR2 with the
data of the operating module

-4-

Overwrite PAR1 with the data of the
operating module

-5-

Overwrite PAR2 with the data of the
operating module

-6-

Transmit PAR1 and PAR2 to the
operating module

Page 7-10

C004

¤ Switch-on display

-0-

Field frequency f

-1-

Unit load

-2-

Motor current

Page 7-62

Show/Hide Bookmarks