Apple Color 1.5 - Manual (Page 429)

Tangent Devices CP200 Series Control Surface
The Tangent Devices CP200 is a modular series of controllers all designed to work together.
MEM
ALT
GRACE DELETE
OUT IN MARK
CUE
DO UNDO
MORE
REDO 7
4
1
00 0
2 3 -
5 6 +
8 9
PREV NEXT
MODE
CLEAR
F1 F2 F3
F4 F5 F6
F7 F8 F9
To use the CP200 series of control surfaces with Color, you need the following:
• A CP200-BK Trackerball/Knob panel, CP200-TS Transport/Selection Panel, CP200-K Knob
Panel, and/or CP200-S Selection Panel
• Multiport hub or switch
• Cat-5 Ethernet cables
Important: The CP200 series control surfaces cannot be connected to the second Ethernet
port of your Mac Pro; they must be connected to your computer’s primary Ethernet port,
if necessary through a hub or switch if you need to share the port with an Internet
connection.
For more information, see:
• Configuring the CP200 Series Control Surfaces
• Controls in the CP200-BK (Trackerball/Knob Panel)
• Controls in the CP200-TS (Transport/Selection Panel)
• Controls in the CP200-K (Knob/Button Panel)
Configuring the CP200 Series Control Surfaces
The following procedures describe how to configure and use these control surfaces with
Color.
To set up the CP200 series controllers for use with Color
1 Connect each of the CP200 devices to the router, hub, or switch that’s connected to your
computer.
429 Appendix D Setting Up a Control Surface