Apple Color 1.5 - Manual (Page 174)

The Settings 1 Tab
The timing properties listed in the Settings 1 tab are not editable. Instead, they reflect
each shot’s position in the Timeline and the properties of the source media that each
shot is linked to.
• Project In and Project Out: Defines the location of the shot in the Timeline.
• Trim In and Trim Out: Defines the portion of source media that’s actually used in the
project, relative to the total available duration of the source media file on disk. The
Trim In and Trim Out timecodes cannot be outside the range of Source In and Source
Out parameters.
• Source In and Source Out: Defines the start and end points of the original source media
on disk. If Trim In is equal to Source In and Trim Out is equal to Source Out, there are
no unused handles available in the source media on disk—you are using all available
media.
• Frame Rate pop-up menu: This pop-up menu lets you set the frame rate of each clip
individually. This setting overrides the Frame Rate setting in the Project Settings tab.
For most projects using source media in the QuickTime format, this should be left at
the default settings. For projects using DPX image sequences as the source media, this
pop-up menu lets you change an incorrect frame rate in the DPX header data.
174 Chapter 7 Timeline Playback, Navigation, and Editing