Apple Color 1.5 - Manual (Page 421)

Color is compatible with control surfaces from JLCooper and Tangent Devices.
A control surface lets you make simultaneous adjustments to multiple parameters while
you work. Not only is this faster, but it allows you to interactively make complex color
adjustments to different areas of the image at once. This appendix describes how to
connect and configure compatible control surfaces to your computer for use with Color.
This appendix covers the following:
• JLCooper Control Surfaces (p. 421)
• Tangent Devices CP100 Control Surface (p. 426)
• Tangent Devices CP200 Series Control Surface (p. 429)
• Customizing Control Surface Sensitivity (p. 434)
JLCooper Control Surfaces
JLCooper makes a variety of control surfaces that are compatible with both Color and
Final Cut Pro. The MCS family of control surfaces have both navigational and color
correction–specific controls in a variety of configurations. The Eclipse CS is an improved
version of the MCS-3000 and MCS-Spectrum that combines both units into a single control
surface.
B3 R3
B2
B1 R1
R2
PAGE 5
PAGE 6
PAGE 8
PAGE 7
PAGE 1
PAGE 2
PAGE 4
PAGE 3
F1
M1
W1
W2
W3
W4
W5
W6
W7
JOG SHUTTLE
M2 M3
1 2 3 4 5 6 7 8 BANK 1
BANK 2
HOURS MINUTES SECONDS FRAMES
BANK 4
BANK 4
PAGE
ASSIGN
UTILITY
M4 M5
TIME CODE DISPLAY F2
F3
F4
F5
F6
F7
F8
To use compatible JLCooper control surfaces with Color, you need the following:
• Eclipse CX, MCS-3000, MCS-3400, or MCS-3800 with an MCS-Spectrum
421
Setting Up a Control Surface
A
p
p
endix
D