Toshiba Magnia 7010 User Manual

Page 82

Installing Hardware
Installing expansion cards

Rotating the I/O lockdown bracket

4 Partially unlock the I/O lockdown bracket of the card or slot cover above the

slot in which you are installing the card. Pull the I/O lockdown bracket up a
little past 90 degrees, so that the bottom of the lock does not obstruct access
to the target slot. Do not unlock it fully, because the card or slot cover could
drop down.

5 Install the expansion card level with the server. Be careful not to catch the

card on the slot’s top and bottom tabs.

6 Secure the I/O lockdown bracket for the installed card by pulling it away

from the card and rotating it forward and down. Return the I/O lockdown
bracket to the slot above it to the fully locked position.

Securing the I/O lockdown bracket

7 Replace the server covers.

8 Plug in the power cable and switch on the server.

NOTE: The settings of the jumper switches on the card and DIP switches
may have to be changed. Some expansion cards also need to be set up
using the System Setup Utility (SSU).

Installing a RAID controller board

1 If the server is running, shut it down, set the AC switch on the back of the

server to OFF and unplug the power cable.

2 Remove the server covers.