Toshiba Magnia 7010 - Manual (Page 126)

System Configuration Setup
Built-in SCSI utility 110
5 Enter the number of Expansion Disk Chassis ID.
6 Enter the new number of power supplies and fans. The program will
respond with “OK”. To exit the program, press the escape key.
7 The program will show the number of power supplies (PS) and fans(FAN)
again when you press any key.
8 Remove the floppy disk from floppy disk drive.
9 Turn off the server.
10 Turn off the Expansion HDD Chassis.
Built-in SCSI utility
The factory presets the built-in SCSI controller. Use this utility when installing
internal SCSI devices in the server’s 5.25-inch device bay or when verifying the
settings.
TOSHIBA SMC Configuration Program for ExHddChas-
sis VerX.XX
*** Setup Redundant ***
ID=3
PS Unit Count : 0X
FAN Unit Count : 0X
*** Redundant Setting ***
SET PS Unit Count ([1]-[4] or [Esc]) >> X OK!
SET FAN Unit Count ([1]-[2] or [Esc]) >> X OK!
*** Setup Redundant END ***
HIT ANY KEY
TOSHIBA SMC Configuration Program for ExHddCha-
sis VerX.XX
*** Setup Redundant ***
[1] ID=1 PS:2 FAN:2
[2] ID=2 PS:2 FAN:2
[3] ID=3 PS:2 FAN:2
[4] ID=4 PS:2 FAN:2
[Esc] Escape
Select Target ExHddChassis ([1]-[4] or [Esc]) >>