Toshiba Magnia 7010 - Manual (Page 25)

Getting Started
Front with doors open
9
The Shortcut switch is a user-defined switch that enables predefined software.
See the “Server Setup Tool User’s Guide” for instructions on installing software
for the Shortcut switch.
The Power On/Off switch turns power on or off.
ON—Press until you hear an audible sound, then release it.
OFF—Press until the sound has changed to continuous one, then release it.
If you release the button before the sound has changed to continuous one,
the server will not shut down.
TECHNICAL NOTE: In security mode, the power on/off switch and reset
switch are disabled, so power cannot be switched off and the system
cannot be reset. To use these buttons, enter the user password.
If a floppy disk drive, CD-ROM, or a hard disk drive activity lamp is lit, do not
reset the system, or remove the side covers. Data could be lost or
destroyed.
The procedures for switching power on and off vary depending on the
system.
LCD Display
The LCD display shows the following information.
1 System configuration information
2 User settings
3 Fault information
The screen changes every few seconds automatically to show the next set of
information.
1 System configuration information
The CPU type, the CPU’s operating frequency, and the memory capacity
are displayed. If there are two 550MHz CPUs and the system memory is
2048MB, the following will be displayed:
The system configuration information is updated during POST processing.
2 User settings
PentiumIII Xeon
550MHzX2 2048MB
APL