Toshiba Magnia 7010 - Manual (Page 36)

Getting Started
Removing and replacing the server panels 20
4 Use the handles to draw the server from the rack. Pull slowly until the server
will go no farther.
Removing the covers on the rack version
5 Release the panel lock.
6 Remove the panels.
Replacing the server covers on the pedestal model
NOTE: Before replacing the server covers, make sure that the server’s AC
switch is OFF and the power cable is unplugged.
1 Replace the top panel.
2 Replace the side panel, being careful not to trap or pinch any internal cables.
3 Turn the panel lock until the finger grip is vertical.
4 Check that the server panels are secure and locked, then reattach and close
the front door.
NOTE: Be sure to lock the side panels after you replace them. If you do not
lock the panels, they can be removed even if you lock the front door.
Replacing the covers on the rack model
1 Replace the panels.
2 Turn the panel lock on the front panel until the finger grip is horizontal.
3 Push the rail release switches and push the server back into the rack.
4 Tighten the thumbscrews.
5 Reconnect the monitor and keyboard cables.
6 Reconnect the power cable and switch on the server.
Panel lock
Thumbscrew
Extraction handle
Thumbscrew
Extraction handle