Toshiba Magnia 7010 - Manual (Page 45)

Getting Started
Switching off the server
29
The entered values take effect when you restart the system. POST uses these
values to configure the hardware. If the values and the actual hardware do not
agree, POST generates an error message. You must then run Setup to specify
the correct configuration.
Switching off the server
The method for switching off power varies depending on the system used.
Check your system and use either the Automatic Shutdown function or the
normal method to switch off power. Be sure to use only one of these two
methods. If you use both methods, power will not be switched off normally.
Normal shutdown
Use this method if the operating system does have not automatic shutdown
function installed:
1 Shut down the operating system in the normal way (see the specific
operating system manual for details).
2 Press the power on/off switch until the buzzer has changed to continuous
sound.
If you release the power on/off switch before the buzzer has changed to
continuous sound, the exit process is interrupted and power remains on.
Using the Automatic Shutdown function
The Automatic Shutdown function operates with Windows NT only. Other
systems will be switched off as soon as the power on/off switch is turned off. If
the special software is not installed in a Windows NT system, the Automatic
Shutdown function will not operate. When you are not using the Automatic
Shutdown function, be sure to terminate system operation before turning off the
server.
Before using this function, you need to install it. See “Server Setup Tool User’s
Guide”.
To switch off the server using the Automatic Shutdown (ASD) function: