Toshiba Magnia 7010 - Manual (Page 147)

Troubleshooting Guide
Toshiba Technical Support
131
command during the SCSI ROM boot. Please change any SCSI BIOS defaults
to properly start all hard disk drives during its ROM load. Most notably, this
setting is necessary on all Adaptec controllers.
Please refer to the user’s manual of the installed RAID controller for additional
details on configuring the SCSI BIOS.
Status LED indications
If you observe any of these indications, call your authorized Magnia service
provider as soon as possible:
NOTE: If the POWER indicator glows amber, this does not indicate
anything wrong. It shows that AC power input is normal and that there is no
DC output.
Forced shutdown
If you perform a forced shutdown and your system will not restart when you
press the power on/off switch, reset the AC switch on the back of the server,
then turn on the power again.
Toshiba Technical Support
If you have problems, or if you need assistance, call Toshiba Technical Support.
LED State Possible Cause
Power Off AC power not supplied
Flashing amber Invalid number of power supplies
Disk Amber Faulty HDD
Fault Flashing green and
amber Fan/power supply failure