Toshiba Magnia 7010 - Manual (Page 100)

System Configuration Setup
System Setup Utility (SSU) 84
Option: Onboard Disk Controllers
Settings: Onboard Floppy Controller:Enable-Primary
Usage: Enable or Disable the IDE controller. The default setting is Enable-Primary.
Settings: Onboard IDE Controller: Disable Primary channel
Usage: Enable or Disable the IDE controller. The default setting is Disable- Primary
and Secondary channels.
NOTE: When installing an expansion card having a diskette controller (in
the case of some SCSI cards), make the floppy diskette control function on
the card invalid. For its setting method, refer to the operation manual for the
corresponding card.
Option: Onboard Communication Devices Group
Settings: Serial Port 1 Configuration 3F8 - IRQ4
Usage: I/O port address and interrupt level of Serial Port 1 can be set.
Settings: Serial Port 2 Configuration2F8 - IRQ3
Usage: I/O port address and interrupt level of Serial Port 2 can be set.
Settings: Parallel Port Configuration378h - IRQ7 : Output Only Mode
Usage: I/O port address and interrupt level and Operation mode of Printer Port can be
set.
All settings are recommended values.
Option: Floppy Drive Subsystem Group
Settings: Floppy Drive A Options3.5-inch 1.44/1.25 MB drive
Usage: Do not change this setting
Settings: Floppy Drive B Options Disable or Not Installed
Usage: The type of connected FDD is set. The standard FDD mounted is Drive A. Do
not change these settings. All settings are recommended values.
Option: IDE Subsystem Group
These settings are for the IDE hard disk and are disabled in the server.
Option: Keyboard Group
Settings: NumLock OFF
Usage: NumLock function automatically is set or disabled when you boot up.
Settings: Key ClickDisable
Usage: Do not change this setting.