Toshiba Magnia 7010 - Manual (Page 51)

Installing Hardware
Installing optional devices
35
DANGER: Be sure to disconnect the AC power cables prior to removing
any optional devices. Some parts carry high voltages and are dangerous to
touch.
When installing or removing optional devices, protect your hands from
injury from sharp edges or hot components. Wait for the components to
cool.
™ Use the appropriate size of screwdriver for each screw. A screwdriver that is
too small or too large can damage the screw head.
™ Be careful not to lose any screws or drop them inside the equipment.
™ Before disconnecting any cables, check their positions to make sure you
reconnect them correctly.
™ Check cable connectors for broken or bent pins. If a cable connector has
screws, tighten them to fasten the cable securely.
WARNING: Do not operate the server without the side or top panels in
place. Replace the panels before switching on power.
To avoid damage from static electricity, when handling a device that has an
exposed board, do not touch the board’s ICs or other components.
Once you remove a device from an antistatic package, if necessary, place it
with its IC side up on a flat, grounded surface. Store the antistatic package.
Never slide the server when you move it.
NOTE: Installing optional devices and equipment in the rack model requires
special knowledge and techniques. If you have no experience installing
such equipment, or if the job seems difficult, Toshiba recommends that you
consult your authorized Magnia service provider.