Toshiba Magnia 7010 - Manual (Page 76)

Installing Hardware
Adding and removing a hard disk drive (HDD) 60
Pulling the release lever
7 When the disk drive is fully released, carefully pull the drive module out of
the disk bay.
Pulling the disk drive out of the bay
NOTE: Before removing the HDD, make sure that it is faulty. The STATUS
lamp under a faulty HDD glows amber to indicate a malfunction. If an
operational HDD is removed by mistake, it could cause a failure or destroy
programs and data.
8 Insert a new hard disk as described in the additional hard disk installation
procedures. For more information, see “Installing additional hard disk
drives” on page 57.
9 Check that the drive’s DC POWER indicator glows green.
10 Attach the HDD EMI cover.
11 Close the front door.