Toshiba Magnia 7010 - Manual (Page 79)

Installing Hardware
Installing expansion cards
63
Removing the fan module rail
8 Cable A in the illustration above is the power cable. Connect it from the
power supply back panel to the HDD cage.
9 Cable B in the illustration above is the signal cable. Connect it from the
SMC board to the HDD cage.
10 Connect the SCSI cable to the expansion HDD cage and lay the cable along
the floor of the server.
11 Connect the other end of the cable to the on board SCSI Controller or RAID
board.
12 Seat the fan rail base and secure it with two screws.
13 Install the fan unit as described in “Fan module installation/removal” on
page 37.
14 Secure the Front frame with six screws.
NOTE: If you have no experience installing such equipment, or if the job
seems difficult, consult your authorized Magnia service provider.
Installing expansion cards
ISA and PCI expansion cards can be installed in the server. There are six PCI
slots and one shared PCI/ISA slot. For more information on ISA and PCI card
specifications, see “Expansion slots (for ISA Cards)” on page 145, or see “” on
page 147.
Restrictions on ISA expansion cards
An ISA expansion card requiring a power supply of -5V cannot be used in the
shared PCI/ISA slot because -5V is not supplied to the slot.
Fan unit rail base cable A (Power) cable B (Signal)
SCSI cable