Toshiba Magnia 7010 - Manual (Page 60)

Installing Hardware
Adding a CPU 44
1 If the server is in use, shut it down, set the AC switch on the back of the
server to OFF and unplug the power cable.
CAUTION: Installing a CPU with the power on could damage the CPU and/
or the server.
2 Remove the server covers. See “Removing and replacing the server panels”
on page 19.
WARNING: Do not install an additional CPU or replace a CPU immediately
after switching off power. To protect yourself from burns, wait until the heat
around the CPU slot dissipates.
3 Open the latch to a CPU slot.
Opening the CPU slot
4 Disconnect the sub fan cable and release the two thumbscrews securing the
CPU fan unit.
5 Pull out the CPU fan unit.