Toshiba Magnia 7010 - Manual (Page 81)

Installing Hardware
Installing expansion cards
65
About BBS
“BBS” stands for BIOS Boot Specification. If both the System BIOS and SCSI
controller are BBS-compliant, you can use the System BIOS to select the
magnetic disk device which boots the system, regardless of the slot position the
SCSI controller is connected to.
Both onboard SCSI Controller and RAID Controller are compatible to BBS.
Installing the expansion card
WARNING: When installing or removing expansion cards, protect your
hands from possible injuries caused by sharp projections on the boards and
the server.
Do not touch any parts except those necessary for installing the device.
There are many high-voltage parts that are dangerous to touch. Be sure to
unplug the AC power cable before you start.
1 If the server is running, shut it down, set the AC switch on the back of the
server to OFF and unplug the power cable.
2 Remove the server covers.
3 Rotate the I/O lockdown bracket down at the slot where you intend to install
the card.
PCI Slot No. Boot Order
Onboard SCSI Controller (Wide) 3
PCI Slot A1 1
PCI Slot A2 2
PCI Slot A3 4
PCI Slot B1 5
PCI Slot B2 6
PCI Slot B3 7
PCI Slot B4 8