Toshiba Magnia 7010 - Manual (Page 66)

Installing Hardware
Adding internal SCSI devices 50
Removing the upper device bay bezel
2 Remove the spacer unit by depressing the tabs and pulling it out.
Removing the spacer
To insert a new device, remove the server’s side panel to access the cabling
connections. For more information on removing the side panel, see “Removing
and replacing the server panels” on page 19.
NOTE: The mounting rails on the spacers should be used when installing
devices in the drive bay.
Installing a SCSI device
1 If the server is running, shut it down, set the AC switch on the back of the
server to OFF and unplug the power cable.
CAUTION: Installing an internal SCSI device while the power is on could
damage the device and/or the server.