Toshiba Magnia 7010 - Manual (Page 121)

System Configuration Setup
CMOS Setup Utility
105
™ BIOS Boot Spec Support
Enables or disables the BBS.
To use the BBS, set this setting to “Enabled”.
For details on the BBS, see “Cautions When Adding RAID Controllers and
SCSI Host Adapters” on page 64.
™ Boot Device Priority
Sets the boot priority of the devices when the system is booted up.
On this system, ATAPI CD-ROM is disabled.
™ Hard Drive
Sets the boot priority of the hard disk drives when the system is booted up.
This setting is enabled when BIOS Boot Spec Support is set to “Enabled”.
Do not change the values set to other settings.
Exit menu
™ Exit Saving Changes
Saves changes and restarts the system. Same effect as pressing F10 .
™ Exit Discarding Changes
Discards changes and starts loading the operating system.
™ Load Setup Defaults
Returns all settings to the factory preset values (except for the passwords).
Same effect as pressing
F9 .
™ Load Custom Defaults
Returns all settings to the values saved by “Save Custom Defaults.”
™ Save Custom Defaults
Saves the current settings for reloading in the future using “Load Custom
Defaults.”
™ Discard Changes
Restores the settings that were in effect when the Setup Utility started
(except for the passwords).
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Load Custom Defaults
Save Custom Defaults
Discard Changes
Save Changes