Toshiba Magnia 7010 - Manual (Page 146)

Troubleshooting Guide
Troubleshooting 130
Common problems
This section lists some common problems and their solutions. If you are unable
to resolve the problem, contact a authorized Magnia service provider or your
sales office.
POWER indicator does not light
™ Is the server connected to an AC outlet?
™ Is the AC switch on?
™ Is the server operating normally? If so, the POWER LED may be defective.
Screen is blank
™ Is the power switch on?
™ Is the keyboard securely connected?
™ Is the video signal cable connected correctly?
™ Is the monitor connected to an AC outlet? Is it switched on?
™ Are the brightness and contrast of the monitor adjusted correctly?
™ Are the display switch settings correct?
™ Is the security mode on?
Characters displayed on the screen are distorted or abnormal
™ Are the brightness, contrast, and other monitor controls adjusted correctly?
Refer to the monitor user’s manual.
™ Are the video signal cable and the monitor’s power cable connected
correctly?
FDD indicator does not light
™ Is the floppy disk drive correctly installed? Are its cables securely
connected?
™ Are the settings for the floppy disk drive correct?
HDD indicator does not light
™ Is the SCSI cable inserted into the SCSI controller correctly?
™ Is the hard disk drive installed correctly?
SCSI hard disk drives do not respond
As a system requirement, internal hard disk drives are not started at power up.
Problems may arise if a third-party SCSI controller fails to send a “start unit”