Toshiba Magnia 7010 - Manual (Page 116)

System Configuration Setup
CMOS Setup Utility 100
Latency Timer
Do not change this setting.
Active Termination
Sets the terminator to enabled/disabled. Do not change the settings.
Single-Ended Force/Auto Set
Sets the data transfer method to Force (forced single-ended mode) or Auto
(automatic selection). Do not change the settings.
PCI devices
Set the PCI device. Do not change the settings.
™ I/O Device Configuration
The following submenu appears.
Serial port A/Serial port B
Base I/O address
Set I/O port addresses for serial port A (1) and serial port B (2).
Interrupt
Set interrupt levels for serial port A (1) and serial port B (2).
→ (Onboard Communications Devices) Serial Port 1 Configuration/Serial
Port 2 Configuration/Serial Port 2 Mode
Parallel port
Mode
Set the operation mode of the parallel port to Output Only.
Base I/O Address
Set an I/O port address for the parallel port.
Interrupt
Set an interrupt level for the parallel port.
→ (Onboard Communication Devices) Parallel Port Configuration/Parallel
Port Mode
Serial port A: [Enabled]
Base I/O address: [3F8]
Interrupt: [IRQ 4]
Serial port B: [Enabled]
Base I/O address: [2F8]
Interrupt: [IRQ 3]
Parallel port: [Enabled]
Mode: [Output only]
Base I/O address: [378]
Interrupt: [IRQ 7]
Floppy disk controller: [Enabled]
PS/2 Mouse [Auto]