Xerox WorkCentre M24-6082 - Manual (Page 41)

IPP Configuration
Exiting the IPP Selection Menu
To exit the IPP Selection Menu, which returns you to the Port Settings Menu, press the rectangular Close
button in the upper right corner of the touch screen.
Exiting the Port Settings Menu and returning to the Printer's Main Menu
1. To exit the Port Settings Menu, returning to the Printer's Main screen, press the rectangular Close
button in the upper right corner of the Port Settings Menu screen.
2. Press the rectangular Close button in the upper right corner of the Ports and Protocols selection (two-
button) screen.
3. Press the rectangular Close button in the upper right corner of the five-button screen containing the
Network Settings button.
4. Finally, press the rectangular Exit button in the upper right corner of the four-button, System Settings
screen.
Note: If you changed any settings in the Port Settings menu, the Printer will automatically reboot to register and
enable your new settings.
Configuring IPP Settings with Internet Services
1. Open your Web browser and enter the TCP/IP address of the Printer in the Address or Location field.
Press Enter.
2. Click the Properties button or Tab.
3. Click the plus (+) symbol to the left of the Protocol Settings file folder.
4. Select IPP in the directory tree.
5. The available selections include
Port Number, with a default value of 631. This is the port number assigned by IANA (Internet Assigned
Numbers Authority). It does not need to be changed.
Additional Port Number Entry box.
A TBCP Filter checkbox (displayed when PostScript is enabled).
Administrator Mode Checkbox. This is disabled by default. Consult the On-Line Help for use of this
feature.
DNS Enablement Checkbox.
Connect Timeout Entry Box.
6. Verify that the DNS Enablement Checkbox is checked (enabled) by default. If enabled, the DNS Server
will be available to resolve Host Names to IP Addresses, in support of printing with IPP.
7. Enter a Time Out value for jobs being sent to the Printer through this Port. This is the length of time that
the Controller will wait for an end of job command before printing the current job.
8. Click the Apply New Settings button to accept changes, or the Restore Settings button to return
settings to their previous values. Note: Setting changes are not applied until you restart the Printer.
file:///C|/0-web/boxster/WorkCentreM24-System-Analyst-Guide/Pages/B14_IPP.htm (2 of 2) [9/4/03 8:32:36 AM]