Xerox WorkCentre M24-6082 - Manual (Page 184)

Configure LPD
Configure LPD
N5.6
1. Open your Web browser and enter the TCP/IP address of the Printer in the Address or Location field.
Press Enter.
2. Click the Properties button or Tab.
3. Click the plus symbol (+) to the left of the Protocol Settings file folder.
4. Select LPD in the directory tree.
5. The available selections include:
Port Number, with a default value of 515. As this is the port for the TCP Spooler
assigned by the IANA (Internet Assigned Numbers Authority), the default value should
not need to be changed.
A TBCP Filter checkbox (displayed when PostScript is enabled).
Connect Time-out Entry Box.
6. Enter a Time Out value for jobs being sent to the Printer through this Port. This is the length of time that
the Controller will wait for an end of job command before printing the current job.
7. Click the Apply New Settings button to accept the changes, or the Restore Settings button to return
the settings to their previous values.
NOTE: Changes to settings are not applied until you restart the Printer. A remote Reboot button is available on
the Status Tab of Internet Services.
file:///C|/0-web/boxster/WorkCentreM24-System-Analyst-Guide/Pages/N5_6_ConfigLPD.htm [9/4/03 8:33:16 AM]