Xerox WorkCentre M24-6082 - Manual (Page 140)

Before You Start
Before You Start
FE1
Internet Fax / Scan to E-mail
Before starting the setup:
1. Ensure the machine is fully functioning in its existing configuration.
2. Ensure the machine has access to a Network with Intranet or Internet connection, is communicating
through TCP/IP, and HTTP is enabled.
3. To configure the system for Internet Fax or Scan to E-mail (SMTP or POP3) you must first obtain the
following information:
Note: POP3 is required for Internet Fax.
SMTP POP3
IP address IP address
Subnet mask Subnet mask
Gateway address Gateway address
Host name SMTP Server address
DNS server address Machine E-mail address
DNS domain name POP3 server address
SMTP server address POP3 user name
Machine E-mail address POP3 user password
Note: The device may already be configured with some of the above information.
Complete a Print Report/List for Fax Mode Settings.
A. Press Machine Status.
B. Touch Billing Meter / Print Report tab.
C. Touch Print Report/List.
D. Touch Fax Mode Settings.
E. Touch Settings List.
F. Touch Settings List - Common Items.
G. Press Start.
4. On the report check the Communications Settings. If TCP/IP is not setup please refer to Network
Connectivity Tab above and setup the environment.
5. Touch Close, or wait one minute for report list to close.
file:///C|/0-web/boxster/WorkCentreM24-System-Analyst-Guide/Pages/fe1-beforestart.htm (1 of 2) [9/4/03 8:33:04 AM]