Xerox WorkCentre M24-6082 - Manual (Page 227)

Safety Notes
Laser safety
CAUTION: Use of controls, adjustments, or procedures other than those specified in this
documentation may result in a hazardous exposure to laser radiation.
This equipment complies with international safety standards. With specific regard to laser safety, the equipment
complies with performance standards for laser products set by government, national, and international agencies
as a Class 1 laser product. It does not emit hazardous light, as the beam is totally enclosed during all phases of
customer operation and maintenance.
Maintenance safety
●
Do not attempt any maintenance procedure that is not specifically described in the documentation that is
supplied with your copier/printer.
●
Do not use aerosol cleaners. The use of supplies that are not approved may cause poor performance of
the copier/printer, and could create a dangerous condition.
●
Use the supplies and cleaning materials only as directed in the documentation that is supplied with your
copier/printer. Keep all of these materials out of the reach of children.
●
Do not remove the covers or guards that are fastened with screws. There are no parts behind these
covers that you can maintain or service.
●
Do not perform any maintenance procedures unless you have been trained to do them by a Xerox
representative or unless a procedure is specifically described in one of the copier/printer Manuals.
Operational safety
Your Xerox equipment and supplies were designed and tested to meet strict safety requirements. These include
safety agency examination, approval, and compliance with established environmental standards.
Your attention to the following safety guidelines will help ensure the continued safe operation of your
copier/printer:
●
Use the materials and supplies specifically designed for your copier/printer. The use of unsuitable
materials may result in poor performance of the machine and possibly a hazardous situation.
●
Follow all warnings and instructions that are marked on or supplied with the machine.
●
Place the machine in a room that provides adequate space for ventilation and servicing.
●
Place the machine on a level, solid surface (not on a thick pile carpet) that has adequate strength to
support the weight of the machine.
●
Do not attempt to move the machine. A leveling device that was lowered when your machine was
installed may damage the carpet or floor.
●
Do not locate the machine near a heat source.
●
Do not locate the machine in direct sunlight.
●
Do not locate the machine in line with the cold air flow from an air conditioning system.
●
Do not place containers of coffee or other liquid on the machine.
●
Do not block or cover the slots and openings on the machine. Without adequate ventilation, the machine
file:///C|/0-web/boxster/WorkCentreM24-System-Analyst-Guide/Pages/SafeNotes.htm (2 of 3) [9/4/03 8:33:28 AM]