Xerox WorkCentre M24-6082 - Manual (Page 38)

Novell NetWare 3.1x (Bindery) Networks
printer services queues on multiple fileservers, the Print Server name must be the same on all fileservers and
the Print Server password must be the same on all fileservers.
Note regarding NetWare 4 (bindery): You can set up the printer on the NetWare 4 Server by performing the
following steps:
1. Create a Bindery Queue
2. Create a Bindery Print Server Name
3. Assign Print Server to Queue.
4. Access Quick setup and change Printer Location from Manual Load to Auto Load (Local).
6. Continue following setup instructions for Internet Services.
Configure NetWare Settings using Internet Services
1. Open your Web browser and enter the TCP/IP address of the Printer in the Address or Location field.
Press Enter.
2. Click the Properties button or Tab.
3. Click the plus symbol (+) to the left of the Protocol Settings file folder.
4. Select NetWare in the directory tree.
5. The available selections include:
A Host Name (Print Server Name) Text box. Use this name in the Server setup of the
Print Server using PCONSOLE.
An Active Mode selection box for Directory (NDS) or Bindery.
A Primary File Server name entry box (Bindery).
A Poll Interval Entry box for Queue Polling Interval (1 - 1000 seconds).
A Number of Search Entry box for SAP frequency (1 - 100 seconds, with the ability to set
to zero, which is off).
Two Password text boxes for logging into the NetWare Server.
A TBCP Filter checkbox (displayed when PostScript is enabled.)
Under the NDS Subject Label there is a text box for NDS Tree, followed by one for NDS
Context.
A Frame Selection box, with a default of Auto sensing. Other selections include Ethernet
II (used when running TCP/IP on your network), Ethernet 802.3 (used for NetWare
versions up to 3.11), Ethernet 802.2 (the default for NetWare 3.12 and later), and
Ethernet SNAP (used on networks running TCP/IP and/or AppleTalk).
A display of the Printer's Network (MAC) address.
A Service Location Protocol (SLP) Active Search Enablement box. For use with NetWare
5 and newer versions, this protocol helps to reduce service advertising network traffic.
6. Either accept the default Device (Print Server) Name or type in a new name that matches the name
used on the Server.
7. Select Bindery as your network Mode.
8. Provide the name of the Primary Server.
9. Enter in a polling rate for Queue Polling Interval.
10. Enter in a SAP (service advertising protocol) frequency, or set SAP frequency to zero (off).
11. Type a Password for the Printer to log into the NetWare Server, and type it a second time for
confirmation.
12. For Frame Selection, if in doubt, leave the setting at its Auto sensing default value.
13. Click the Apply New Settings button, then click the Reboot button to reboot the Printer and apply
setting changes.
file:///C|/0-web/boxster/WorkCentreM24-System-Analyst-Guide/Pages/B4_NetWare3_Bindery.htm (2 of 3) [9/4/03 8:32:36 AM]