Xerox WorkCentre M24-6082 - Manual (Page 181)

Configure TCP/IP Settings
Configure TCP/IP Settings
N5.3
1. Open your Web browser and enter the TCP/IP address of the Printer in the Address or Location field.
Press Enter.
2. Click the Properties button or Tab.
3. Click the plus symbol (+) to the left of the Protocol Settings file folder.
4. Select TCP/IP in the directory tree.
5. Review the available selections as displayed on your screen and explained in the TCP/IP
Configuration Selection List, below.
6. Accept the default Host Name, or type in your own unique Host Name for this Printer.
7. Select the desired method for obtaining an IP Address.
8. If Manual is selected, type in the addresses that apply for IP Address, Subnet Mask, and Gateway.
NOTE: If DHCP or BOOTP addressing method is selected, you cannot manually change the IP
Address, Subnet Mask, or Gateway. Select Manual if you wish to manually enter in these addresses.
CAUTION: Changing the IP address for the Printer will affect NetBIOS/IP, LPR/LPD, FTP, SNMP, and
Port 9100 printing. It will also interrupt the ability to communicate with the printer using the Internet
Services (series of web pages on the Printer). When you change the Printer's IP Address, make sure to
print out a Settings List (as stated in this guide) so that you have a record of the TCP/IP addresses for
use with workstations that need to communicate with the Printer using TCP/IP.
DHCP TIP: When using DHCP, set a reasonably long Lease Time for the IP Address so that the Printer
can be restarted, as required when changing operating parameters, without being continuously
assigned a new IP Address.
9. Determine the method to use to supply the DNS Server IP Addresses (to resolve Host Names with IP
Addresses).
10. Determine whether or not Dynamic DNS should be enabled.
11. Determine the method to use to supply the SMTP Server IP Address.
12. Determine the method to use to supply the WINS Server IP Address (to resolve Host Names with IP
Addresses exclusively in an NT environment).
13. Determine whether or not IP Filter should be enabled (to restrict access to the Printer). For more
information, see Restricting Printer Access in this guide.
14. When finished modifying settings, click the Apply New Settings button. To exit the settings screen
without making changes, click the Restore Settings button.
Note: Changes to TCP/IP settings will not be applied until you restart the Printer. A remote Reboot button is
available on the Status Tab of Internet Services.
TCP/IP Configuration Selection List
As displayed on your screen, the following selections are available for TCP/IP Configuration.
file:///C|/0-web/boxster/WorkCentreM24-System-Analyst-Guide/Pages/N5_3_TCPIP.htm (1 of 3) [9/4/03 8:33:16 AM]