Festo Контроллеры двигателя SFC-LAC - Manual (Page 85)

4. The control panel (only type SFC−LACI−...−H2−...)
4−3
Festo GDCP−SFC−LACI−CO−EN en 0812NH
The control panel of the SFC−LACI−...−H2 provides many
functions for commissioning, parameterisation and diagnosĆ
tics. An overview of the key and menu functions can be found
in this chapter.
Commissioning with the control panel is described starting
from section 5.2.
With the SFC−LACI−...−H0 (without control panel), you can
commission the device via the parameterising interface using
the Festo Configuration Tool (FCT). Instructions on this can be
found in section 5.3.2.
Caution
Simultaneous or alternating attempts to access the
SFC−LACI via FCT, control panel and controller interface can
cause unpredictable errors.
· Make sure that the FCT, the control panel and the conĆ
troller interface of the SFC−LACI are not used at the same
time.
· If necessary, use the possibility of blocking parameterisĆ
ing and positioning functions via the control panel (HMI
access, see section 5.5.2)