Festo Контроллеры двигателя SFC-LAC - Manual (Page 247)

B. Parametrising as per FHPP−FPC
B−19
Festo GDCP−SFC−LACI−CO−EN en 0812NH
B.3 Reference FHPP parameters (PNU)
B.3.1 Parameter groups
Group PNU Description
Device data 100..199 Device identification and device−specific settings,
version numbers, identifier words, etc.
Diagnostic memory 200...299 Memory for diagnostic events: fault numbers, fault time,
incoming/outgoing event
Process data 300...399 Current nominal and actual values, local I/Os, status
data etc.
Position set table
(= Record list) 400...499 A record contains all the setpoint value parameters
required for a positioning procedure.
Project data 500...599 Basic project settings. Maximum speed and acceleration,
project zero point offset, etc.
} These parameters form the basis of the position set
table.
Factor group 600...699 (reserved)
Axis data
Electric drives 1 1000...1099 All axis−specific parameters for electric drives. Gear factor,
feed constant, reference parameter, etc.
Axis data
Electric drives 2 1200... Enhancements