Festo Контроллеры двигателя SFC-LAC - Manual (Page 67)

3. Installation
3−15
Festo GDCP−SFC−LACI−CO−EN en 0812NH
Information on commissioning and parameterising the
SFC−LACI via the parametrising interface can be found in
chapter 5.3.2 and in the help system for the Festo
Configuration Tool software package.
Information on transmitting CI commands via the
parameterising interface can be found in Appendix B.
Note
The parameterising interface (RS232) is not electrically
isolated and is not real−time capable. It is not suitable
for permanent connection to PC systems, or as a control
interface.
· Use this terminal only for commissioning.
· Remove the programming cable in continuous
operation.
· Seal the terminal with the protective cap supplied
(type ISK−M8).