Festo Контроллеры двигателя SFC-LAC - Manual (Page 291)

B. Parametrising as per FHPP−FPC
B−63
Festo GDCP−SFC−LACI−CO−EN en 0812NH
B.3.8 Project data
General project data
Project zero point (offset project zero point)
PNU 500 ć int32 rw
Description Offset of the project zero point PZ to the axis zero point AZ.
Reference point for target positions with absolute positioning
(compare PNU 401 and 404).
CI / DS402 21F4h 00h int32 rw
Software end positions
PNU 501 1...2 int32 rw
Description Software end positions in increments. Plausibility rule: Min. limit
Ţ Max. limit
Factory settings: see section 5.2.6.
Lower limit
(lower limit value)
501 1
(lower limit value)
Lower software end position: offset to axis zero point
Upper limit
(upper limit value)
501 2
(upper limit value)
Upper software end position: offset to axis zero point
CI / DS402 607Bh 01h...02h int32 rw