Festo Контроллеры двигателя SFC-LAC - Manual (Page 233)

B. Parametrising as per FHPP−FPC
B−5
Festo GDCP−SFC−LACI−CO−EN en 0812NH
B.1.1 Create readiness to operate
With the transitions only those internal conditions are named
which are new. There must therefore not be any faults for T2.
T Internal conditions Actions of the user
T1 SFC−LACI was switched on.
An error cannot be ascertained.
T2 Load voltage applied.
Fieldbus master must be higher−order conĆ
troller. ENABLE = 1 (drive enabled)
CCON = xxx0.xxx
1
T3 STOP = 1
CCON = xxx0.xx
11
T4 STOP = 0
CCON = xxx0.xx
01
T5 ENABLE = 0
CCON = xxx0.xxx
0
T6 ENABLE = 0
CCON = xxx0.xxx
0
T7* Fault recognised.
T8 Reaction to fault completed, drive stopped.
T9 There is no longer a fault.
It was a serious error. RESET = 0 → 1 (acknowledge fault)
CCON = xxx0. Pxxx
T10 There is no longer a fault.
It was a simple error. RESET = 0
→ 1 (acknowledge fault)
CCON = xxx0. Pxx1
T11 Fault still exists. RESET = 0
→ 1 (acknowledge fault)
CCON = xxx0. Pxx1
Key: P = positive edge, N = negative edge, x = any