Festo Контроллеры двигателя SFC-LAC - Manual (Page 190)

5. Commissioning
5−88
Festo GDCP−SFC−LACI−CO−EN en 0812NH
Parameter / Description CI FCT PNU
Out2: Use
Value
Out 2 is used as:
0 No function
1 Brake output (see 5.6.11)
2 Digital signal display (see FCT)
3 Output/Compare" (see FCT)
1250 x 2422/01h
Out 2: Setting condition
Value
The output is set dependent upon:
1 Position comparison
2 Force comparison
3 Speed comparison
4 Record number comparison
10h Ready
11h Motion complete
12h Error
13h Sample in
14h (reserved)
15h ON (during setting of this bit, the output is set immediately)
1251 x 2422/02h
Out 2: Resetting condition (delay: see 2422/08h)
Value
The output is reset dependent upon:
1 Position comparison + delay
2 Force comparison + delay
3 Speed comparison + delay
4 Record number comparison + delay
10h Ready + delay
11h Motion complete + delay
12h Error + delay
13h Sample in + delay
14h Delay
15h OFF (during setting of this bit, the output is reset immediately)
1252 x 2422/03h
Out 2: Value for setting condition
The saved value that when reached means that the comparison condition
is considered fulfilled in accordance with 2422/02h.
With record number comparison: bit number
Z record number:
bit 1 = record 1 (bit 0: do not use). Example: 0x6 = in record1 and also in
record2, the condition is considered fulfilled and the output is set.
1253 x 2422/04h
Out 2: Value for resetting condition
As above, but in accordance with 2422/03h for the resetting condition. 1254 x 2422/05h