Festo Электроцилиндр - Manual (Page 85)

5 Commissioning
Festo – GDCP-CMMO-ST-EA-SY-EN – 1301a – English 85
5.9.4 Time comparators
The message “Time comparator active” is set when the following condition is fulfilled:
– The time since the start of the record is within the parameterisable limits
( › minimum and š maximum).
In all other cases the message is inactive.
Overview of parameters for time comparators
FCT
Lower time limit (minimum)
1)
x
Upper time limit (maximum)
1)
x
Feedback
You can allocate this signal to digital output 6 or 7 in FCT on the “Digital I/O” panel.
1) The limit values can only be positive. If the minimum value is greater than the maximum value, the condition for the time
comparator is never fulfilled.
Tab. 5.15 Parameters for time comparators