Festo Электроцилиндр - Manual (Page 44)

5 Commissioning
44 Festo – GDCP-CMMO-ST-EA-SY-EN – 1301a – English
5.3 Commissioning via web server
The web server integrated in the CMMO-ST provides access to an English-language parameterisation
and commissioning website, which you can call up with a web browser. Commissioning via the web
server is possible for selected products, i.e. axis mechanisms optimised by Festo.
5.3.1 What does the web server enable?
Parameter files
Uploading and downloading parameter files for initial start-up or for use as backup files.
Homing
Starting a homing run in accordance with the homing method parameterised in the CMMO-ST (default
settings: Tab. 5.2).
The homing run can only be started; a change of the homing method must take place in FCT.
Jogging
Jog mode in both directions.
Teaching
Teaching of up to 7 absolute target positions; parametrisation of speed and acceleration of the result-
ing position records.
Relative target positions cannot be taught. Corresponding position records, however, can be entered by
hand.
Positioning
Starting and stopping the 7 position records.
I/O
Display of the electro-physical status of the inputs and outputs of the I/O interface.
Diagnostics
Read-out of the diagnostic memory and display of the most important controller statuses.
Identification
Wave function: Activating a radio button (“Identify this CMMO”, Fig. 5.2) causes the decimal point in
the 7-segment display of the currently connected CMMO-ST to start flashing.
5.3.2 Parameter files
The parameter files support the initial start-up of your drive. The parameter files corresponding to the
respective drive type can be found:
– on the supplied CD
– on the Festo Support Portal for download
– as “Cloud” parameter on the Festo Internet Server