Festo Электроцилиндр - Manual (Page 29)

3 Mounting
Festo – GDCP-CMMO-ST-EA-SY-EN – 1301a – English 29
3.3 Mounting the controller
You can mount the controller in one of two ways:
1. Threaded connection on a flat surface
2. H-rail mounting
3.3.1 Fitting
You will need 3 or 4 M4 screws, with washers/spring washers if necessary. If a H-rail clip is mounted,
you can remove it.
The following figure shows the location of the holes and recesses that can be used for mounting the
controller:
1 2
1
1 Mounting with 4 screws to the base
(lying flat)
2 Mounting on the side with 3 screws
(vertical)
Fig. 3.2 Mounting with screws
When mounting on the side ( 2 ): To exchange the controller, you only need to loosen the
3 screws by a few rotations, after which the controller can be tilted out.