Festo Электроцилиндр - Manual (Page 10)

1 Safety and requirements for product use
10 Festo – GDCP-CMMO-ST-EA-SY-EN – 1301a – English
1.1.2 Intended use
The CMMO-ST motor controller is used for controlling stepper motors in accordance with the Festo
catalogue, and is especially intended for use with EPCO electric drives.
This description documents the basic functions of the CMMO-ST and the I/O interface.
EPCO drives and additional components are documented in separate operating instructions.
The CMMO-ST and the connectable modules and cables may only be used as follows:
– as intended
– only in an industrial environment
– in perfect technical condition
– in original status without unauthorised modifications (only the conversions or modifications
described in the documentation supplied with the product are permitted)
• Observe the safety instructions and intended use in the documentation for all the components and
modules.
• Observe the standards specified in the relevant chapters, as well as the regulations of the trade
associations, the German Technical Control Board (TÜV), the VDE conditions or relevant national
regulations.
• Observe the limit values for all additional components (e.g. sensors, actuators).
Note
In the event of damage caused by unauthorised manipulation or other than intended
use, the guarantee is invalidated and the manufacturer is not liable for damages.