Festo Электроцилиндр - Manual (Page 7)

CMMO-ST
Festo – GDCP-CMMO-ST-EA-SY-EN – 1301a – English 7
Instructions on this documentation
This documentation is intended to help you safely work with the motor controller CMMO-ST.
Product identification, versions
The hardware version indicates the version status of the CMMO-ST’s electronics. The
firmware version indicates the version status of the operating system.
You can find the specifications of the version status as follows:
– Hardware version and firmware version in the Festo Configuration Tool (FCT) with an
active online connection to the CMMO-ST on the “Controller” panel.
Firmware version from What’s new? Which FCT plug-in?
V 1.0.x Motor controller CMMO-ST with I/O interface
supports the following drives:
– EPCO
– For additional drives: see Festo catalogue
www.festo.com
CMMO-ST V 1.00
V 1.1.2 Advanced parameter settings via web browser From CMMO-ST V 1.1.0
Tab. 1 Firmware Version
Service
Please consult your regional Festo contact if you have any technical problems.