Festo Электроцилиндр - Manual (Page 43)

5 Commissioning
Festo – GDCP-CMMO-ST-EA-SY-EN – 1301a – English 43
5.2.5 Initial start-up via Ethernet
The CMMO-ST will need to be connected directly to a computer/laptop for the initial start-up phase.
The CMMO-ST cannot be connected immediately to a network during the initial start-up phase, as its
active DHCP server could result in network malfunctions.
1. Switch on the CMMO-ST and connect it to your computer/notebook by using a standard Ethernet
cable (connector: RJ-45). The cable type, i.e. whether it has a straight or crossed connection, is
detected automatically. The DHCP server in the CMMO-ST will now assign an IP address to your
computer, enabling you to access the CMMO-ST (requirement: a DHCP client is active on your com-
puter = default setting for most computers).
Fig. 5.1 Initial start-up via direct connection
2. Launch your web browser (activate Internet Explorer >6; Firefox >3; JavaScript) and type the IP
address of the CMMO-ST into the address bar (default setting: 192.168.178.1). The CMMO-ST
website will now appear ( section 5.3).
3. Alternatively to the web browser, you can also install the FCT software from the CD. The FCT soft-
ware makes more complex configurations possible than the web browser does ( section 5.4).
If you cannot establish a connection to the CMMO-ST: section 6.4.3.