Allied Telesis AT-S94 CLI (AT-8000S Series) - Manual (Page 98)

Page 97
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
Parameters
•
seconds — Specify, in seconds, the update frequency (Range: 600 - 86400 ).
Default Configuration
1200
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the update frequency of the DHCP snooping binding file.
ip dhcp snooping binding
The ip dhcp snooping binding Privileged EXEC mode command configures the DHCP snooping binding
database and adds binding entries to the database. Use the no form of this command to delete entries from the
binding database.
Syntax
ip dhcp snooping binding mac-address vlan-id ip-address {ethernet interface | port-channel port-channel-
number} expiry seconds
no ip dhcp snooping binding mac-address vlan-id
Parameters
•
mac-address — Specify a MAC address
• vlan-id — Specify a VLAN number
• ip-address — Specify an IP address
• interface — Specify Ethernet port
• port-channel-number — Specify Port-channel number
• expiry seconds — Specify the interval, in seconds, after which the binding entry is no longer valid (Range: 10
- 4294967295)
Default Configuration
No static binding exists
Command Mode
Privileged EXEC
User Guidelines
After entering this command an entry is added to the DHCP snooping database. If DHCP snooping binding file
exists, the entry is added to that file also.
console(config)# ip dhcp snooping database update-freq 1500