Power inline priority – Allied Telesis AT-S94 CLI (AT-8000S Series) User Manual
Page 210

Page 209
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures a description to an IP-phone to a powered device connected to Ethernet
interface 1/e1.
power inline priority
The power inline priority Interface Configuration (Ethernet) mode command configures the inline power
management priority of the interface. Use the no form of this command to return to the default configuration.
Syntax
power inline priority {critical | high | low}
no power inline priority
Parameters
•
critical — Indicates that operating the powered device is critical.
•
high — Indicates that operating the powered device has high priority.
•
low—Indicates that operating the powered device has low priority.
Default Configuration
The default setting is low priority.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the device connected to Ethernet interface 1/e1 as a high-priority powered
device.
console(config)# interface ethernet 1/e1
console(config-if)# power inline powered-device IP-phone
console(config)# interface ethernet 1/e1
console(config-if)# power inline priority high