beautypg.com

Lldp management-address – Allied Telesis AT-S94 CLI (AT-8000S Series) User Manual

Page 179

background image

LLDP Commands

Page 178

Syntax

lldp optional-tlv tlv1 [tlv2 … tlv5]

no lldp optional-tlv

Parameters

tlv — Specifies the TLV that should be included. Available optional TLVs are: port-desc, sys-name,

sys-desc, sys-cap and 802.3-mac-phy.

Default Configuration

No optional TLV is transmitted.

Command Mode

Interface Configuration (Ethernet) mode.

User Guidelines

There are no user guidelines for this command.

Example

The following example specifies which optional TLV (2)s from the basic set should be transmitted.

lldp management-address

The lldp management-address Interface Configuration mode command specifies the management address that
is advertised from an interface. Use the no form of this command to revert to the default setting.

Syntax

lldp management-address ip-address {automatic|none}

no management-address

Parameters

ip-address — Specifies the management address to advertise.

automatic — Specifies that the software will automatically choose a management address to advertise. This

will be the system's currently configured IP address. All addresses are advertised (both Static and DHCP).

none — Specifies not to advertise any address.

Default Configuration

No IP address is advertised.

Command Mode

Interface Configuration (Ethernet) mode.

console(config)# interface ethernet e5

console(config-if)# lldp optional-tlv sys-name