Allied Telesis AT-S94 CLI (AT-8000S Series) - Manual (Page 38)

Page 37
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
Syntax
service-acl input acl-name
no service-acl input
Parameters
•
input — Applies the specified ACL to the input interface.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet, Port-Channel) mode
User Guidelines
In advanced mode, when an ACL is bound to an interface, the port trust mode is set to trust 12-13 and not to 12.
Example
The following example, binds (services) an ACL to Ethernet interface e2.
show access-lists
The show access-lists Privileged EXEC mode command displays Access Control Lists (ACLs) configured on the
switch.
Syntax
show access-lists [name]
Parameters
•
name — Name of the ACL.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
console(config)# interface ethernet e2
console(config-if)# service-acl input macl1